Trying Out the Instrument
R&S
®
RTO
53Getting Started 1316.0833.02 ─ 10
The "High" measurement is selected and enabled, using the selected (focused)
waveform as the source.
The "Measurements" result box with the measured amplitude is displayed.
4.
To display statistical results for the measurement, tap the icon in the result
box, or press the MEAS key on the front panel (in the ANALYSIS area).
The "Measurements" dialog box is displayed.
5. Enable the "Statistics" option, and close the dialog box.
The results in the result box are extended by statistical values.
6.
To select further measurements, tap the
icon in the result box, or press the
MEAS key on the front panel to display the "Measurements" dialog box.
7. Under "Additional amplitude/time measurements", tap "Activate..." and select the
required measurement types. For example, select Low, Amplitude, Min, and Max to
display the high level, low level, minimum and maximum values, respectively.
The measurement results are displayed in the result box.
8.
To save space in the display, minimize the result box: . The most important
results are displayed and updated in the result icon, as well.
9. To view all measurement results without covering part of the waveform display,
move the result table to its own diagram area:
a) Drag the result icon to the diagram area.
b) Drop the icon in the target area.
Now you can see both the measurement results and the waveform.
Showing Basic Measurement Results
To Next Page
Loading...
