Connecting the R&S SFE100
R&S
®
SFE100
30Getting Started 2112.4122.62 ─ 13
To uninstall a USB device
► Disconnect the USB device from the R&S
SFE100. You can do this during opera-
tion.
Windows XP immediately detects the change in the hardware configuration and
deactivates the corresponding driver.
6.3.1 External Keyboard
Connect the keyboard to one of the USB interfaces (type A). The default language set-
ting is for a UK keyboard. You can change the language and modify other settings
such as the repetition rate in Windows XP.
Changing Regional and Language Settings
1.
Open the "Start" menu by pressing the WINDOWS key on an external keyboard.
2. Select "Control Panel" and then "Keyboard" or "Regional and Language Options".
Table 6-1: Corresponding keys: front panel - external keyboard (model 02, 03)
Key on front panel Corresponding key on key-
board
Function description
Cursor keys LEFTARROW, RIGHTARROW,
UPARROW, DNARROW
See Chapter 5.1.3, "Cursor Keys",
on page 19
BACK BACKSPACE See
Chapter 5.1.1, "Hardkeys", on page 17
OK ENTER "
LOCAL F3 "
RF ON/OFF CTRL+F1 "
During remote operation, you can use the following virtual keys provided in the "HARD-
KEY" menu. These keys are not available on the front panel.
Table 6-2: Corresponding keys: virtual keys - external keyboard
Virtual key Corresponding key on key-
board
Function description
HELP F1 Opens and closes the context-sensitive help
function.
For details see user manual or the help sys-
tem
ASSIGN F2 Starts management of favorites.
For details see user manual or the help sys-
tem
LOCAL F3 Switches from remote control or remote oper-
ation to manual operation.
For details see user manual or the help sys-
tem
Connecting External Devices
To Next Page
Loading...
