Installed Software
R&S
®
SFE100
55Getting Started 2112.4122.62 ─ 13
2. Under "Select Backup", select the backup to be restored.
3. Click "Restore"
and follow the instructions.
4. After the recovery, turn off/on the R&S SFE100 manually.
10.3.3.3 Recovering the Factory Default
Only R&S SFE100 models 12, 13.
1.
In the "Windows
XP Embedded Recovery and Backup Partition" dialog (see "To
display the Windows XP Embedded Recovery and Backup Partition dialog"
on page 51), click "Factory Default" to recover the factory version of the system
partition.
The "Factory Default" dialog is displayed. It shows the versions of the firmware and
the software platform on delivery.
2. Click "Recover now" and follow the instructions.
Windows XP Recovery and Backup Partition
To Next Page
Loading...
