Signal generator settings
R&S
®
SGS100A
114User Manual 1173.9105.02 ─ 13
Figure 9-2: Connecting power sensors to the R&S
SGS via R&S NRP-Z5 sensor hub
I, II = Connection order
G = Signal source (R&S SGS)
1 = USB type Micro-A connector
2 = USB Adapter Micro-A to A
3 = Standard USB cable with USB type A and USB type B connectors
4 = USB type B connector
4a = External power supply unit, incl. power cable (supplied with the R&S NRP-Z5)
5 = Cable R&S NRP-ZK6 per sensor of the R&S NRPxx power sensor family; no further adapter cables for
sensors of the R&S NRP-Zxx family
Using USB hub
Figure 9-3 illustrates the connection as principle. For details, see the description
R&S
®
NRP
®
Series Power Sensors getting started.
Figure 9-3: Connecting power sensors to the R&S
SGS via USB hub
I, II = Connection order
G = Signal source (R&S SGS)
1 = USB type Micro-A connector
2 = USB Adapter Micro-A to A
3 = Standard USB cable with USB type A and USB type B connectors
4 = USB type B connector
4a = External power supply unit and extra power cable
5 = Cable R&S NRP-ZKU per sensor of the R&S NRPxx power sensor family; R&S NRP-Z3 or R&S NRP-
Z4 USB adapter cables for sensors of the R&S NRP-Zxx family
Connection order
Always connect the equipment in the following order:
1. Connect the R&S NRP-Z5 sensor hub or the USB hub to the power supply and to
the R&S SGS
2. Switch on the R&S SGS
Level and power-on settings
To Next Page
Loading...
