Signal generator settings
R&S
®
SGS100A
117User Manual 1173.9105.02 ─ 13
Add LAN Sensor settings ← Add Sensor settings
Configures settings to add sensors connected to the R&S SGS via LAN.
"IP Address or Host Name"
Displays the host name or the IP address of a R&S NRP power sen-
sor.
If the R&S SGS does not detect a connected R&S NRP sensor, you
can assign the address information manually.
"Add LAN Sensor"
Adds a detected R&S NRP sensor connected in the LAN to the list of
sensors, including its device ID or name and its serial number.
Remote command:
:SLISt:SCAN:LSENsor on page 248
Add USB Sensor settings ← Add Sensor settings
Configures settings to add sensors connected to the R&S SGS via USB.
"Device ID or Sensor Name"
Displays the device identifier or the name of the R&S NRP power
sensor.
If the R&S SGS does not detect a connected R&S NRP sensor, you
can assign the ID or name manually.
"Serial Number"
Displays the serial number of the R&S NRP power sensor.
If the R&S SGS does not detect a connected R&S NRPsensor, you
can assign the serial number manually.
"Add USBTMC Sensor"
Adds a detected R&S NRP sensor connected at the USB interface to
the list of sensors, including its device ID or name and its serial num-
ber.
Remote command:
:SLISt:SCAN:USENsor on page 249
9.5.8.3 NRP power viewer
The R&S SGS features the power viewer function for measuring or monitoring signals
with R&S NRP power sensors.
About
The R&S SGS can perform up to four power measurements simultaneously.
The measured signals can be the RF output power or other selected signal sources.
Depending on the signal characteristic (CW, AM, pulsed, etc.) or the parameter to be
measured (average, peak, etc.) a suitable R&S power sensor must be used.
Level and power-on settings
To Next Page
Loading...
