General instrument settings and instrument setup
R&S
®
SGS100A
151User Manual 1173.9105.02 ─ 13
The new password is only valid after the "Change Password" button is pressed.
Change Password ← Security Password
Changes the password accordingly.
Security Settings
Comprises the settings for enabling and disabling the USB and LAN interfaces. The
setting requires the entry of the security password and is only accepted after the
"Accept" button is pressed.
USB Storage ← Security Settings
Enables/disables the access to external USB storage media.
The instrument does not recognize any device connected to the USB interface when
the interface is disabled.
To apply the change: enter the security password and confirm with "Accept". Otherwise
the change has no effect.
Note: Remove all USB memory devices before disabling the USB storage. If any USB
memory device remains connected, disabling is blocked, and the instrument returns a
warning message.
LAN Interface ← Security Settings
Enables/disables the LAN interface.
Note: It is not possible to access the instrument via LAN while the LAN connection is
disabled.
An enabled LAN connection is a prerequisite for the remote control of the instrument
via VNC, FTP or SAMBA.
To disable the LAN interface enter the security password and confirm with "Accept".
Otherwise the change has no effect.
Security Password ← Security Settings
Enters the password that is required to enable or to disable the settings protected by a
security password. The default is '123456'.
Note: It is highly recommended to change the default security password before con-
necting the instrument to the network. To change the security password, select
"SGMA-GUI > Instrument Name > Setup > Security > Change Security Password".
The settings are only accepted after the "Accept" button is pressed.
Accept ← Security Settings
Accept a new entry or selection and change the settings accordingly.
10.7 Network settings
The instrument is equipped with a network interface and can be connected to an Ether-
net LAN (local area network). The "Network Settings" dialog provides access to the
network settings.
Network settings
To Next Page
Loading...
