Rohde & Schwarz R&S SGS100A - Remote Channels

General instrument settings and instrument setup
R&S
®
SGS100A
154User Manual 1173.9105.02 ─ 13
Default Gateway
Displays the IP address of the default gateway. To enter the default gateway manually,
select "Address Mode > Static".
This address identifies the router on the same network as the instrument that is used to
forward traffic to destinations beyond the local network.
It is recommended that a connection of the instrument to the network is coordinated
with the network administrator. Connection errors can affect the entire network.
Remote command:
:SYSTem:COMMunicate:NETWork[:IPADdress]:GATeway on page 294
Apply
Applies the network settings to the instrument.
10.8 Remote channels
Access:
► Select "SGMA-GUI > Instrument Name > Setup > Remote".
The "Remote" dialog provides access to the settings for remote control.
Settings
Visa Resource Strings.................................................................................................154
Device Identity.............................................................................................................155
Visa Resource Strings
Indicates the VISA resource strings used for remote control of the instrument. A sepa-
rate string is provided for remote control via the different interfaces.
Remote channels