Rohde & Schwarz R&S SGS100A - Calibration Subsystem

Remote control commands
R&S
®
SGS100A
227User Manual 1173.9105.02 ─ 13
Example:
SYST:FPR
all instrument settings (also those that are not currently active)
are reset to the factory values.
Usage: Event
Manual operation: See "Execute Factory Preset" on page 155
13.5 CALibration subsystem
:CALibration:ALL[:MEASure]?......................................................................................... 227
:CALibration:FREQuency[:MEASure]?..............................................................................227
:CALibration:IQModulator:FULL?..................................................................................... 228
:CALibration:IQModulator:LOCal?....................................................................................228
:CALibration:LEVel[:MEASure]?.......................................................................................228
:CALibration:LEVel:TEMPerature?................................................................................... 228
:CALibration:FREQuency:TEMPerature?..........................................................................228
:CALibration:IQModulator:TEMPerature?..........................................................................228
:CALibration:OEXTension................................................................................................229
:CALibration:ROSCillator:DATA:MODE.............................................................................229
:CALibration:ROSCillator[:DATA]......................................................................................229
:CALibration:ALL[:MEASure]?
Starts all internal adjustments for which no external measuring equipment is needed.
Return values:
<All> 1 | ON | 0 | OFF
Example: See Chapter 13.1.1, "Performing general tasks for instrument
setup", on page 213.
Usage: Query only
Manual operation: See "Adjust All" on page 142
:CALibration:FREQuency[:MEASure]?
Performs all adjustments which affect the frequency.
Return values:
<Synthesis> 1 | ON | 0 | OFF
Example: See Chapter 13.1.1, "Performing general tasks for instrument
setup", on page 213.
Usage: Query only
Manual operation: See " Synthesis" on page 143
CALibration subsystem