Rohde & Schwarz R&S SGS100A - Page 232

Remote control commands
R&S
®
SGS100A
232User Manual 1173.9105.02 ─ 13
:EXTension:INSTruments:NAME?
Queries the list of the symbolic names of the available extension devices.
Usage: Query only
Manual operation: See "Available Instruments" on page 138
:EXTension:INSTruments:SCAN[:STATe] <State>
Starts a scan for the available extension instruments.
Parameters:
<State> 0 | 1 | OFF | ON
1
Starts scan.
0
Aborts scan.
*RST: OFF
Example: See Chapter 13.1.5, "Enabling and configuring an extension
mode", on page 219.
Manual operation: See "Available Instruments" on page 138
See "Scan" on page 139
:EXTension:INSTruments:REMote:CHANnel?
Queries the remote channels of the available extension instruments. Possible interfa-
ces are: LAN, USB, SOCKet, PCIe.
Parameters:
<Channel> <Channellnstr#1>[,<Channellnstr#2>,...]
Returns a list of the used remote channels of the available
extensions, one interface per instrument. If an extension uses
more than one remote channels, the fastest one is returned.
Example: See Chapter 13.1.5, "Enabling and configuring an extension
mode", on page 219.
Usage: Query only
Manual operation: See "Available Instruments" on page 138
:EXTension:INSTruments:REMote:LAN:NAME?
Queries the IP addresses/instrument names of the available extension instruments.
Return values:
<IPAddress> <IPAdr_Inst#1>[,<IPAdr_Inst#2>,...]
Example: See Chapter 13.1.5, "Enabling and configuring an extension
mode", on page 219.
EXTension subsystem