Rohde & Schwarz R&S SGS100A - Page 233

Remote control commands
R&S
®
SGS100A
233User Manual 1173.9105.02 ─ 13
Usage: Query only
Manual operation: See "Available Instruments" on page 138
:EXTension:INSTruments:REMote:SERial?
Queiries the serial numbers of the available extension instruments.
Parameters:
<Serial> <SerialNumberInstr#1>[, <SerialNumberInstr#2>,...]
Example: See Chapter 13.1.5, "Enabling and configuring an extension
mode", on page 219.
Usage: Query only
Manual operation: See "Available Instruments" on page 138
:EXTension:BUSY[:STATe]?
Queries the state of the extension instrument.
Return values:
<State> 0 | 1 | OFF | ON
0
The extension is connected to the master instrument and can be
remotely operated.
1
The extension is busy, i.e. in standby or locked state, or is per-
forming a time consuming operation.
Example: See Chapter 13.1.5, "Enabling and configuring an extension
mode", on page 219.
Usage: Query only
Manual operation: See "Available Instruments" on page 138
:EXTension:SELect <SelNr>
Selects an extension by its index number. The subsequent SCPI commands are rela-
ted to this extension.
Parameters:
<SelNr> float
0
no selection
Example: See Chapter 13.1.5, "Enabling and configuring an extension
mode", on page 219.
EXTension subsystem