Instrument tour
R&S
®
SGS100A
37User Manual 1173.9105.02 ─ 13
●
Chapter 3.13.2, "Connecting a remote PC via LAN", on page 30
[ID]
The [ID] key allows you to identify your R&S SGS, e.g. in complex test setups with
more instruments.
The following applies if the R&S SGS is connected to a remote controller with
R&S SGMA-GUI installed:
●
Press the [ID] key identify your R&S SGS on the remote controller. In the dialog
"SGMA-GUI > Setup > Instruments > Configure Instruments > Edit Instrument", the
R&S SGS is active.
●
Set "Edit Instrument > Device Identify > On" to identify your R&S SGS from the
remote controller. The LED of the [ID] key is orange and blinking.
Table 4-5: Overview of [ID] key states
[ID] state LED Remark
Identification
blinking orange
Identification of the R&S SGS.
Off/Inactive
gray
No identification.
4.2 Rear panel tour
This section provides an overview of the connectors on the rear panel of the instru-
ment. For technical data of the connectors, refer to the data sheet.
1
2 3 4 5
8 7 6
Figure 4-2: R&S
SGS rear panel controls and connectors
1 = AC power supply connector and power switch
2 = PCIe
3 = LAN
4 = USB In
5 = RF 50Ω
6 = LO IN, LO OUT, REF IN, REF OUT
7 = TRIG
8 = I/Q
AC power supply connector and power switch
Mains power switch for performing the following tasks:
●
Connecting the internal power supply to the power source
●
Disconnecting the internal power supply from the power source
How to: Chapter 3.6, "Connecting to power", on page 22
Rear panel tour
To Next Page
Loading...
