Trying out the Instrument
R&S
®
SGS100A
39User Manual 1173.9105.02 ─ 13
5 Trying out the Instrument
This section provides examples on how to configure the R&S SGS to generate a con-
tinuous wave (CW) signal via the R&S SGMA-GUI and the R&S SGS100A Web-GUI.
5.1 Configuring a CW Signal with the R&S SGMA-GUI
The R&S SGS in this example is a base unit equipped with the frequency option
R&S SGS-B106.
As a prerequisite for this example, the R&S SGS has to be connected to a remote PC.
The R&S SGMA-GUI software has to be installed on this remote PC and the instru-
ment is added to the list of "Available Instruments".
Figure 5-1: Example of the setup
For information on how to fulfill these requirements, refer to
●
Chapter 3.13.2.1, "Connecting to the network", on page 30
●
Chapter 3.13.1, "Installing the R&S SGMA-GUI software", on page 28
●
Chapter 3.13.2.3, "Adding instruments to R&S SGMA-GUI", on page 32
1. Check the front panel of the R&S SGS.
The [POWER ON/STANDBY] and [LAN] key have to be green.
2. On the connected remote PC, start the R&S SGMA-GUI software application.
The main panel of the application opens. The panel provides a quick access to the
main settings of the configured and activated instruments. The display shows one
row per instrument with the instrument-specific settings. The rows comprise the
instrument, the connection state, the used frequency and power level, the state of
the RF output and the modulator and the used reference frequency source.
Configuring a CW Signal with the R&S SGMA-GUI
To Next Page
Loading...
