Trying out the Instrument
R&S
®
SGS100A
42User Manual 1173.9105.02 ─ 13
The serial number is displayed at the rear side of the instrument. It is the third part
of the device ID printed on the bar code sticker, see Figure 5-2.
Figure 5-2: Serial number of the R&S SGS100A
The main panel of the R&S SGS100A Web-GUI opens.
In the R&S SGS100A Web-GUI main panel, the green indicator "System Status >
OK " confirms that there is a connection between the instrument and the remote
PC and that the instrument is recognized by the software.
If you want to get additional information about the instrument, click on the "Device
Name". For additional information on other settings, hold the mouse cursor over
the specific setting.
Error messages are also displayed in the R&S SGS100A Web-GUI. If you want to
hide an error message, click on it.
4. In the menu bar on the left side press " Preset" to restore the predefined instru-
ment's settings.
5. Select "Frequency" and adjust the setting as required.
6. Select "RF On" to enable the output of the CW signal.
A signal with the set frequency is output at the "RF 50Ω" connector at the rear
panel of the .
Configuring a CW Signal with the R&S SGS100A Web-GUI
To Next Page
Loading...
