System overview
R&S
®
SGS100A
51User Manual 1173.9105.02 ─ 13
5. In the R&S SGMA-GUI main panel, the green indicator in front of the instrument's
name confirms that there is a connection between the instrument and the remote
PC. Also, it confirms that the software recognizes the instrument.
6. Select "SGMA-GUI main panel > R&S SGS > Extension".
The "Extension" dialog opens.
Tip: Instrument does not appear in the extension dialog. If the R&S SGU is not
automatically shown in this dialog press "Scan > Start" to find the instrument.
7. Select the R&S SGU from the list.
8. Set "Available Instruments > Select > On" to enable it as an extension.
A green status indicator "Connected" indicates the successfully established remote
connection between the R&S SGS ant the R&S SGU. The R&S SGMA-GUI indi-
cates the extended frequency range of the R&S SGS and the activated extension
mode.
Connecting an R&S SGS and an R&S SGU
To Next Page
Loading...
