Rohde & Schwarz R&S SGS100A - Working with R&S SGMA-GUI; Saving and Loading Settings; Handling Instruments in the R&S SGMA-GUI

Understanding the R&S SGMA-GUI software
R&S
®
SGS100A
75User Manual 1173.9105.02 ─ 13
Remote command:
[:SOURce]:ROSCillator:SOURce on page 283
LO Scr Ext
This icon indicates that the internal local oscillator is switched off.
See "Source" on page 95.
8.4 Working with R&S SGMA-GUI
This section explains how to work with the R&S SGMA-GUI software and perform con-
figuration tasks for manual operation of the instruments.
8.4.1 Saving and loading settings
To proceed work with a particular configuration of the instruments in the R&S SGMA-
GUI, it is useful to save the used settings and load them again later.
How to save and load settings
1. Select "SGMA-GUI main panel > File > Save As".
2. Navigate to the desired directory.
3. Enter the filename.
The software adds the file extension *.savrcl automatically.
4. Select "Save".
The current settings of the software are saved to the selected file.
5. To load settings from a file, select "SGMA-GUI main panel > File > Open"
6. Navigate to the storage directory of the saved file.
7. Select this file.
Loads the saved settings to the R&S SGMA-GUI and the main panel displays the
saved configuration of the instrument.
8.4.2 Handling instruments in the R&S SGMA-GUI
This section provides information on how to configure and manage instruments in the
R&S SGMA-GUI.
For reference information about all provided settings in the user interface, refer to the
corresponding sections:
●
Chapter 8.1.2.1, "Configure instruments", on page 61 and Chapter 8.1.2.2, "Add/
Edit instruments", on page 65
●
Chapter 8.1.2.3, "Software", on page 67
Working with R&S SGMA-GUI