Understanding the R&S SGMA-GUI software
R&S
®
SGS100A
76User Manual 1173.9105.02 ─ 13
Chapter 8.1.2.4, "Reset SGMA-GUI", on page 68
8.4.2.1 How to add new instruments automatically
1. For each new instrument perform the following steps:
a) Connect the instrument to the network.
b) Switch on the instrument.
c) Press the [ID] key on the front panel of the instrument.
2. Start the SGMA-GUI on a computer connected to the same network.
All instruments are added automatically to the main panel of the SGMA-GUI.
8.4.2.2 How to add new instruments manually
1. In the R&S SGMA-GUI main panel, select "Setup > Instruments".
The Configure Instruments dialog opens.
2. Select the "New" key.
The Add Instrument dialog opens to register a new instrument.
3. In the "Symbolic Name" field, enter an alias name of your choice, e.g.
SGS-100021.
4. In the "Instrument Type" field, select the device family to connect to.
5. To select the hardware interface, select "Remote Control > Hardware Channel".
6. For LAN or Socket interfaces, select "Remote Control > Instrument Name / IP
Address".
7. Enter the IP address or the hostname of the connected instrument, e.g.
rssgs100a100021.
See also Chapter 8.4.3, "Finding out the default hostname of the instrument",
on page 78.
8. For USB or PCIe interfaces, select "Remote Control > Serial Number".
9. Enter the serial number of the connected instrument, e.g., 100021.
10. Set "Active > On" to activate the instrument. Only active instruments are displayed
in the R&S SGMA-GUI main panel.
11. To apply the settings, you have two options:
● Click "OK".
The dialog also closes.
● Click "Apply".
● The dialog remains opened.
Working with R&S SGMA-GUI
To Next Page
Loading...
