Rohde & Schwarz R&S SMA100B - Calculate Subsystem

Remote Control Commands
R&S
®
SMA100B
449User Manual 1178.3834.02 ─ 05
Power and Pulse Data Analysis, Gated Measurements (option R&S SMA100B-
K28)
The power analysis measurement commands are subsumed under the
SENSe[:POWer]:SWEep:… commands. Three measurement modes are available:
Frequency, Power and Time.
The power analysis measurement is started with the
SENSe[:POWer]:SWEep:INITiate command and the measurement result retrieved
with the TRACe[:POWer]:SWEep:… commands.
The four sensors are distinguished by the suffix at the second key word SENSe.
The time gate settings are performed using the CALCulate[:POWer]:SWEep:… com-
mands.
The measurement diagram and results can be stored in a hardcopy with the
SENSe[:POWer]:SWEep:HCOPy:… commands.
General parameter and measurement settings are valid for all connected sensors,
therefore, no suffix is used in these commands.
13.14.1 CALCulate Subsystem
:CALCulate[:POWer]:SWEep:FREQuency:MATH<ch>:STATe.............................................449
:CALCulate[:POWer]:SWEep:FREQuency:MATH<ch>:SUBTract........................................ 450
:CALCulate[:POWer]:SWEep:POWer:MATH<ch>:STATe....................................................450
:CALCulate[:POWer]:SWEep:POWer:MATH<ch>:SUBTract............................................... 450
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:AVERage?.................................................451
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:FEED........................................................451
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:MAXimum?................................................451
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:STARt.......................................................452
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:STOP........................................................452
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:STATe....................................................... 452
:CALCulate[:POWer]:SWEep:TIME:MATH<ch>:STATe.......................................................453
:CALCulate[:POWer]:SWEep:TIME:MATH<ch>:SUBTract.................................................. 453
:CALCulate[:POWer]:SWEep:FREQuency:MATH<ch>:STATe <State>
Activates the trace mathematics mode for "Frequency" measurement. This feature
enables you to calculate the difference between the measurement values of two
traces. For further calculation, a math result can also be assigned to a trace.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
CALC:POW:SWE:FREQ:MATH2:STATe
Switches on math mode in trace 2.
Options: R&S SMAB-K28
Manual operation: See " Mathematics - Trace Power Analysis " on page 228
Power Sensor Measurement Subsystems