Rohde & Schwarz R&S SMW200A - Page 1003

Remote Control Commands
R&S
®
SMW200A
1003User Manual 1175.6632.02 ─ 30
Parameters:
<Time> float
Range: 0.25 to 16
Increment: 0.01
*RST: 1
Default unit: symbol
Example: See Example "Enable power ramping" on page 991
Options: R&S SMW-B10
Manual operation: See "Ramp Time" on page 278
[:SOURce<hw>]:BB:DM:PRAMp:FDELay
<FDelay>
[:SOURce<hw>]:BB:DM:PRAMp:RDELay <RDelay>
Sets the delay in the rising edge.
Parameters:
<RDelay> float
Range: 0 to 4
Increment: 0.01
*RST: 0
Default unit: symbol
Example: See Example "Enable power ramping" on page 991
Options: R&S SMW-B10
Manual operation: See "Rise Delay" on page 278
[:SOURce<hw>]:BB:DM:PRAMp:ATTenuation <Attenuation>
Sets the level attenuation for signal ranges that are flagged with level attribute attenu-
ated by the control signal.
Parameters:
<Attenuation> float
Range: 0 to 50
Increment: 0.1
*RST: 15
Default unit: dB
Example: See Example "Enable power ramping" on page 991
Options: R&S SMW-B10
Manual operation: See "Attenuation" on page 278
[:SOURce<hw>]:BB:DM:PRAMp:BBONly[:STATe] <State>
Enables power ramping in the baseband only or mixed power ramping in the baseband
and the RF section.
SOURce Subsystem