Rohde & Schwarz R&S SMW200A - Page 1011

Remote Control Commands
R&S
®
SMW200A
1011User Manual 1175.6632.02 ─ 30
<BitCount> integer
0 = marker off, 1 = marker on
Range: 1 to 64
*RST: 2
Example: See Example "Adjusting clock, marker and trigger settings"
on page 990.
Manual operation: See "Marker Mode" on page 257
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:PULSe:DIVider <Divider>
Sets the divider for pulse marker mode (PULSe).
*)
If R&S SMW-B9 is installed, the minimum marker duration depends on the sample/
symbol rate.
See "Marker Minimum Duration" on page 234.
Parameters:
<Divider> integer
Range: 2 (R&S SMW-B10) / 2* (R&S SMW-B9) to 1024
*RST: 2
Example: See Example "Adjusting clock, marker and trigger settings"
on page 990
Manual operation: See "Marker Mode" on page 257
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:PULSe:FREQuency?
Queries the pulse frequency of the pulsed marker signal PULSe.
Return values:
<Frequency> float
Example: See Example "Adjusting clock, marker and trigger settings"
on page 990
Usage: Query only
Manual operation: See "Marker Mode" on page 257
[:SOURce<hw>]:BB:DM:TRIGger:OUTPut<ch>:DELay <Delay>
Defines the delay between the signal on the marker outputs and the start of the signal,
expressed in terms of symbols.
Parameters:
<Delay> float
Range: 0 to 16777215
Increment: 0.001
*RST: 0
SOURce Subsystem