Rohde & Schwarz R&S SMW200A - Page 1031

Remote Control Commands
R&S
®
SMW200A
1031User Manual 1175.6632.02 ─ 30
Manual operation: See "Frequency" on page 309
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:OFFSet <Offset>
Sets the DC component.
Parameters:
<Offset> float
Range: -1 to 1
Increment: 0.001
*RST: 0
Default unit: FS
Example: see Example "Creating test signals" on page 1019
Manual operation: See "Offset DC" on page 309
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:SAMPles
<Samples>
Sets the number of sample values required for the rectangular signal per period.
Parameters:
<Samples> integer
Range: 4 to 1000
*RST: 100
Example: See Example "Creating test signals" on page 1019
Manual operation: See "Samples per Period" on page 309
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:FREQuency <Frequency>
Sets the frequency of the simple sinusoidal test signal.
Parameters:
<Frequency> float
Range: 100 to depends on the installed options
Increment: 0.01
*RST: 1000
Default unit: Hz
Example: See Example "Creating test signals" on page 1019.
Manual operation: See "Frequency" on page 307
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:PHASe <Phase>
Sets the phase offset of the sine wave on the Q channel relative to the sine wave on
the I channel.
SOURce Subsystem