Rohde & Schwarz R&S SMW200A - Page 1032

Remote Control Commands
R&S
®
SMW200A
1032User Manual 1175.6632.02 ─ 30
Parameters:
<Phase> float
Range: -180 to 180
Increment: 0.01
*RST: 90
Default unit: DEG
Example: see Example "Creating test signals" on page 1019
Manual operation: See "Phase Offset Q" on page 308
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:SAMPles
<Samples>
Sets the sample rate for the sine signal in samples per period.
The resulting clock rate must not exceed the maximum ARB clock rate (see data
sheet).
The maximum value is automatically restricted by reference to the set frequency and
has to fulfill the rule Frequency * Samples <= ARB clock rate.
Parameters:
<Samples> integer
Range: 4 to 1000
*RST: 100
Example: see Example "Creating test signals" on page 1019
Manual operation: See "Samples per Period" on page 308
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate:NAMed <Filename>
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate:NAMed <Filename>
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate:NAMed <Filename>
Generates a signal and saves it to a waveform file.
Setting parameters:
<Filename> string
Example: See Example "Creating test signals" on page 1019
Usage: Setting only
Manual operation: See "Generate Signal File" on page 308
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:CIQ:CREate
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:RECTangle:CREate
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:CREate
Generates a signal and uses it as output straight away.
Example:
see Example "Creating test signals" on page 1019
Usage: Event
SOURce Subsystem