Rohde & Schwarz R&S SMW200A - Page 1034

Remote Control Commands
R&S
®
SMW200A
1034User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:BB:ARBitrary:COUPled:STATe.............................................................. 1037
[:SOURce<hw>]:BB:ARBitrary:COUPled:TRIGger:DELay:OFFSet.................................... 1037
[:SOURce<hw>]:BB:ARBitrary:WAVeform:CLOCk........................................................... 1038
[:SOURce<hw>]:BB:ARBitrary:WAVeform:CATalog?
Reads out the files extension *.wv in the default directory.
Return values:
<Catalog> string
Returns a list of the file names separated by commas
Example: see Example "Managing waveform files" on page 1020
Usage: Query only
[:SOURce<hw>]:BB:ARBitrary:WAVeform:CATalog:LENGth?
Reads out the files with extension *.wv in the default directory and returns the number
of waveform files in this directory. The default directory is set using command
MMEM:CDIRectory.
Return values:
<Length> integer
Number of waveform files in default directory
Range: 0 to INT_MAX
*RST: 0
Example: see Example "Managing waveform files" on page 1020
Usage: Query only
[:SOURce<hw>]:BB:ARBitrary:WAVeform:SELect <Filename>
Selects an existing waveform file, i.e. file with extension *.wv.
Parameters:
<Filename> string
Example: See Example "Managing waveform files" on page 1020
Manual operation: See "Load Waveform/File" on page 305
[:SOURce<hw>]:BB:ARBitrary:WAVeform:DELete <Filename>
Deletes the specified waveform file. If the file is not on the default path, the path must
be specified at the same time. The file extension may be omitted. Only files with the file
extension *.wv are deleted.
Setting parameters:
<Filename> string
Example: See Example "Managing waveform files" on page 1020
SOURce Subsystem