Remote Control Commands
R&S
®
SMW200A
1035User Manual 1175.6632.02 ─ 30
Usage: Setting only
[:SOURce<hw>]:BB:ARBitrary:WAVeform:FREE?
Queries the free disk space on the default path of the instrument's hard disk.
Return values:
<Free> integer
Range: 0 to INT_MAX
*RST: 1
Example: See Example "Managing waveform files" on page 1020
Usage: Query only
[:SOURce<hw>]:BB:ARBitrary:WAVeform:POINts?
Queries the number of samples (the number of I/Q values pairs) in the selected wave-
form file.
Return values:
<Points> <waveform filename>
Range: 0 to 1000
*RST: 1
Example: see Example "Managing waveform files" on page 1020
Usage: Query only
[:SOURce<hw>]:BB:ARBitrary:WAVeform:DATA <Filename>, <Data>
[:SOURce<hw>]:BB:ARBitrary:WAVeform:DATA? <Tag>
The setting command writes the binary block data <data> to the file identified by
<filename>. The complete content of the waveform file (i.e. including all tags) must
be specified; the complete content is transmitted as binary data block.
I/Q data and the marker data can also be written to a file with the command :
MMEMory:DATA:UNPRotected.
Tip: To ensure trouble-free data transmission, set the GPIB delimiter to EOI.
The query command retrieves the content of the specified tag of the currently selected
waveform file or the waveform file specified with the <filename>.
See also Chapter 5.7.5, "Tags for Waveforms, Data and Control Lists", on page 327.
Parameters:
<Filename> string
Specifies the name of the waveform file in that the binary data is
copied
Setting parameters:
<Data> block data
SOURce Subsystem
To Next Page
Loading...