Rohde & Schwarz R&S SMW200A - Page 1052

Remote Control Commands
R&S
®
SMW200A
1052User Manual 1175.6632.02 ─ 30
Use the command [:SOURce<hw>]:BB:ARBitrary:MCARrier:OFILe to define
the multi-carrier waveform file name. The file extension is *.wv.
Example: See Example "Generating a multi carrier signal" on page 1026
Usage: Event
Manual operation: See "Create/Create and Load" on page 390
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CLOCk?
Queries the resulting sample rate at which the multi-carrier waveform is output by the
arbitrary waveform generator. The output clock rate depends on the number of carriers,
carrier spacing, and input sample rate of the leftmost or rightmost carriers.
Return values:
<Clock> float
Range: 400 to Max
Increment: 1E-3
Example:
BB:ARB:MCAR:CLOC?
Queries the ARB multi-carrier output clock rate.
Usage: Query only
Manual operation: See "Clock Rate" on page 390
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CREate
Creates a multi-carrier waveform using the current settings of the carrier table.
Use the command [:SOURce<hw>]:BB:ARBitrary:MCARrier:OFILe to define
the multi-carrier waveform file name. The file extension is *.wv.
Example:
See Example "Generating a multi carrier signal" on page 1026
Usage: Event
Manual operation: See "Create/Create and Load" on page 390
[:SOURce<hw>]:BB:ARBitrary:MCARrier:CARRier<ch>:STATe <State>
Enables/diasbled the selected carrier.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Generating a multi carrier signal" on page 1026
Manual operation: See "State" on page 392
SOURce Subsystem