Rohde & Schwarz R&S SMW200A - Page 1066

Remote Control Commands
R&S
®
SMW200A
1066User Manual 1175.6632.02 ─ 30
Maximum trigger delay and trigger inhibit values depend on the installed options. See
"Specifying delay and inhibit values" on page 242.
Parameters:
<Delay> float
Range: 0 to depends on the sample rate
Increment: 0.01
*RST: 0
Default unit: sample
E.g. 0 to 2147483647 samples (R&S SMW-B10)
Example: see Example "Managing waveform files" on page 1020
Manual operation: See "(Specified) External Delay/(Specified) Trigger Delay"
on page 255
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal]:TDELay
<ExtTimeDelay>
Specifies the trigger delay for external triggering. The value affects all external trigger
signals.
Maximum trigger delay and trigger inhibit values depend on the installed options. See
"Specifying delay and inhibit values" on page 242.
Parameters:
<ExtTimeDelay> float
Range: 0 to 2147483647 / (clock frequency)
Increment: 1E-9
*RST: 0
Default unit: s
Example: See Example "Specifying delay and inhibit values in time units"
on page 1022.
Manual operation: See "(Specified) External Delay/(Specified) Trigger Delay"
on page 255
[:SOURce<hw>]:BB:ARBitrary:TRIGger[:EXTernal]:RDELay?
Queries the time (in seconds) an external trigger event is delayed for.
Return values:
<ResTimeDelaySec> float
Range: 0 to 688
Increment: 0.25E-9
*RST: 0
Example: See Example "Specifying delay and inhibit values in time units"
on page 1022
Usage: Query only
Manual operation: See "Actual Trigger Delay/Actual External Delay" on page 256
SOURce Subsystem