Rohde & Schwarz R&S SMW200A - Page 1095

Remote Control Commands
R&S
®
SMW200A
1095User Manual 1175.6632.02 ─ 30
Example: See Example "Generating an additive noise signal"
on page 1091
Manual operation: See "Reference Mode" on page 427
[:SOURce<hw>]:AWGN:BRATe <BRate>
Sets the bit rate used for calculation of bit energy to noise power ratio.
Valid units are bps, kbps and mabps as well as b/s, kb/s and mab/s.
Parameters:
<BRate> float
Range: 400 to depends on the installed options
Increment: 0.001
*RST: 100000
Example: see Example "Generating an additive noise signal"
on page 1091
Manual operation: See "Bit Rate" on page 427
[:SOURce<hw>]:AWGN:CNRatio <CnRatio>
Sets the carrier/interferer ratio.
Parameters:
<CnRatio> float
Range: -50 to 45
Increment: 0.01
*RST: 0
Example: See Example "Generating an additive noise signal"
on page 1091
Manual operation: See "Carrier/Noise Ratio, Signal/Noise Ratio" on page 427
[:SOURce<hw>]:AWGN:ENRatio <EnRatio>
Sets the ratio of bit energy to noise power density.
Parameters:
<EnRatio> float
Range: -50 to depends on the installed options
Increment: 0.01
*RST: 15.84
Default unit: dB
Example: See Example "Generating an additive noise signal"
on page 1091
Manual operation: See "E
b
/N
0
" on page 427
SOURce Subsystem