Rohde & Schwarz R&S SMW200A - Page 1098

Remote Control Commands
R&S
®
SMW200A
1098User Manual 1175.6632.02 ─ 30
Parameters:
<Target> float
Range: -40E6 to 40E6
Increment: 0.01
*RST: 0
Example: see Example "Generating a CW interferer signal" on page 1090
Manual operation: See "Target CW Frequency Offset" on page 425
[:SOURce<hw>]:AWGN:FREQuency:RESult?
Queries the actual frequency of the sine wave.
Return values:
<Result> float
Range: -40E6 to 40E6
Increment: 0.01
*RST: 0
Example: see Example "Generating a CW interferer signal" on page 1090
Usage: Query only
Manual operation: See "Resulting CW Frequency Offset" on page 430
14.19.4.6 SOURce:BB:IMPairment Subsystem
This subsystem contains the commands for the analog and digital I/Q impairments.
Suffixes
The following suffixes are used:
Suffix Value range Description
RF<ch>,
IQOutput<ch>
1 to 2 IQ connector
BBMM<ch>
1 to 2 DIG IQ connector
FADer<ch>
1 to 4 DIG IQ connector
Required options
See Chapter 6.4.1, "Required Options", on page 440.
[:SOURce]:BB:IMPairment:BBMM<ch>:DELay................................................................1099
[:SOURce]:BB:IMPairment:FADer<ch>:DELay................................................................ 1099
[:SOURce]:BB:IMPairment:IQOutput<ch>:DELay............................................................ 1099
[:SOURce]:BB:IMPairment:RF<ch>:DELay.....................................................................1099
[:SOURce<hw>]:IQ:IMPairment:IQRatio[:MAGNitude]......................................................1100
[:SOURce]:BB:IMPairment:BBMM<ch>:IQRatio[:MAGNitude]........................................... 1100
[:SOURce]:BB:IMPairment:FADer<ch>:IQRatio[:MAGNitude]............................................1100
SOURce Subsystem