Rohde & Schwarz R&S SMW200A - Page 1106

Remote Control Commands
R&S
®
SMW200A
1106User Manual 1175.6632.02 ─ 30
Parameters:
<Mode> STRA | STRB | STRC | STRD | STRE | STRF | STRG | STRH
*RST: STRA
Example:
SCONfiguration:OUTPut:MODE DIGM
SCONfiguration:APPLy
SOURce1:BB:GRAPhics:MODE PSP
SOURce1:BB:GRAPhics:FFTLen LEN2048
SOURce1:BB:GRAPhics:SOURce DO1
SOURce1:BB:GRAPhics:SOURce:MUX STRA
SOURce1:BB:GRAPhics:TRIGger:SOURce SOFT
SOURce1:BB:GRAPhics:SRATe:MODE AUTO
SOURce1:BB:GRAPhics:ADD MIN
Manual operation: See "Mux Stream" on page 607
[:SOURce]:BB:GRAPhics:FFTLen
<Mode>
Sets the FFT size.
Parameters:
<Mode> LEN256 | LEN512 | LEN1024 | LEN2048 | LEN4096 | LEN8192
*RST: LEN2048
Example:
SOURce:BB:GRAPhics:FFTLen LEN2048
Manual operation: See "FFT Length" on page 607
[:SOURce]:BB:GRAPhics:FFTFscale <State>
Defines the normalization of the power values in the power spectrum diagram.
Parameters:
<State> 0 | 1 | OFF | ON
1
Normalized power in dBFS
0
Shows power distribution in dB/Hz
*RST: 0
Example:
SOURce:BB:GRAPhics:FFTFscale PSPectrum
SOURce:BB:GRAPhics:FFTFscale 1
// the power spectrum shows the normalized power in dBFS
Manual operation: See "Full Scale (dBFS)" on page 607
[:SOURce<hw>]:BB:GRAPhics:TRIGger:SOURce <Source>
Defines the trigger for the starting time of the graphic recording.
SOURce Subsystem