Rohde & Schwarz R&S SMW200A - Page 1112

Remote Control Commands
R&S
®
SMW200A
1112User Manual 1175.6632.02 ─ 30
Example: see Example "Querying information on burst baseband signals
using the multi-gated acquisition" on page 1107
Manual operation: See "Add, Change, Remove, Start, Abort" on page 629
[:SOURce]:BB:MEASurement:POWer:CHANge
Triggers the instrument to adopt the changed measurement configuration.
Example: See Example "Querying information on burst baseband signals
using the multi-gated acquisition" on page 1107
Usage: Event
Manual operation: See "Add, Change, Remove, Start, Abort" on page 629
[:SOURce]:BB:MEASurement:POWer:EXECute
Example:
Triggers the instrument to perform the configured measurement.
Example: See Example "Querying information on burst baseband signals
using the multi-gated acquisition" on page 1107
Usage: Event
Manual operation: See "Add, Change, Remove, Start, Abort" on page 629
[:SOURce]:BB:MEASurement:POWer:ABORt
Stops the current measurement.
Example:
See Example "Querying information on burst baseband signals
using the multi-gated acquisition" on page 1107
Usage: Event
Manual operation: See "Add, Change, Remove, Start, Abort" on page 629
[:SOURce]:BB:MEASurement:POWer:DELete
Removes the selected measurement from the list.
Example:
See Example "Querying information on burst baseband signals
using the multi-gated acquisition" on page 1107
Usage: Event
Manual operation: See "Add, Change, Remove, Start, Abort" on page 629
14.19.4.9 SOURce:BB:PROGress Subsystem General Commands
In the R&S SMW, some calculation processes take longer time. While operating the
instrument manually, you can observe the status of an initiated process by the busy
indicator. The following commands fulfill the same task in the remote control operation.
SOURce Subsystem