Rohde & Schwarz R&S SMW200A - Page 1122

Remote Control Commands
R&S
®
SMW200A
1122User Manual 1175.6632.02 ─ 30
14.19.5.3 Frequency Response Commands
This section lists the frequency response commands related to the I/Q modulator.
Example: Enabling high-quality optimization
SOURce1:CORRection:FRESponse:RF:OPTimization:MODE QHIG
SOURce1:CORRection:FRESponse:RF:OPTimization:BANDwidth:MODE AUTO
SOURce1:CORRection:FRESponse:RF:OPTimization:BANDwidth:VALue?
// 160000000
SOURce1:CORRection:FRESponse:RF:OPTimization:LOCal
SOURce1:CORRection:FRESponse:RF:OPTimization:HOLD:STATe 1
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:MODE..................................1122
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:BANDwidth:MODE................ 1123
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:BANDwidth[:VALue]...............1123
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:HOLD[:STATe]...................... 1123
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:LOCal.................................. 1123
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:MODE
<FreqRespOptMode>
Sets the optimization mode.
The value selected here is used also as optimization mode in the I/Q modulator, and
vice versa.
For details, see R&S SMW User Manual.
Parameters:
<FreqRespOptMode> FAST | QHIGh | QHTable
FAST
Optimization by compensation for I/Q skew.
QHTable
Enabled if R&S SZU is connected to the R&S SMW and the con-
nection is active.
Improved optimization by maintained speed.
QHIGh
Optimization by compensation for I/Q skew and frequency
response correction.
This mode interrupts the RF signal. Do not use it in combination
with the uninterrupted level settings and strictly monotone
modes RF level modes
*RST:
FAST
*RST: QHIGh / QHTable (if R&S SZU connected to R&S SMW
and the connection is active)
Example:
See Example "Enabling high-quality optimization" on page 1122.
SOURce Subsystem