Rohde & Schwarz R&S SMW200A - Page 1123

Remote Control Commands
R&S
®
SMW200A
1123User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:BANDwidth:MODE
<FreqRespOptBwMo>
For [:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:MODE
QHIG|QHT, sets how the signal bandwidth is estimated: automatically or manually with
the command [:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:
BANDwidth[:VALue].
Parameters:
<FreqRespOptBwMo>AUTO | MANual
*RST: AUTO
Example: See Example "Enabling high-quality optimization" on page 1122.
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:BANDwidth[:VALue]
<FreqRespOptBwVa>
Sets the signal compensation bandwidth for [:SOURce<hw>]:CORRection:
FRESponse:RF:OPTimization:BANDwidth:MODE MAN.
Parameters:
<FreqRespOptBwVa> integer
Range: depends on installed baseband extension option
*RST: = max. bandwidth (depending on istalled options)
* e.g. 8E6 to 120E6 (R&S SMW-B10); min value also depends
on the system configuration (R&S SMW-B9)
For more information, see data sheet.
Example: See Example "Enabling high-quality optimization" on page 1122.
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:HOLD[:STATe]
<FreqRespHoldSta>
For [:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:MODE
QHIG|QHT, retains the last calculated correction values as long as one of the following
is performed:
●
SOURce1:CORRection:FRESponse:RF:OPTimization:HOLD:STATe 0
●
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:LOCal
Parameters:
<FreqRespHoldSta> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Enabling high-quality optimization" on page 1122.
[:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:LOCal
For [:SOURce<hw>]:CORRection:FRESponse:RF:OPTimization:MODEQHIG,
triggers optimization for the current settings.
SOURce Subsystem