Rohde & Schwarz R&S SMW200A - Page 1132

Remote Control Commands
R&S
®
SMW200A
1132User Manual 1175.6632.02 ─ 30
Parameters:
<Span> float
Full freqeuncy range
Increment: 0.01
*RST: 400E6
Example: See Example "Setup an RF frequency or power sweep"
on page 1206
Manual operation: See "Span" on page 514
[:SOURce<hw>]:FREQuency:STARt
<Start>
Sets the start frequency for the RF sweep.
See Chapter 8.7.2.1, "Correlating Parameters in Sweep Mode", on page 501.
Parameters:
<Start> float
Range: 300kHz to RFmax
Increment: 0.01Hz
*RST: 100 MHz
Example: See Example "Setup an RF frequency or power sweep"
on page 1206
Manual operation: See "Start Frequency/Stop Frequency" on page 513
[:SOURce<hw>]:FREQuency:STOP <Stop>
Sets the stop frequency range for the RF sweep.
See Chapter 8.7.2.1, "Correlating Parameters in Sweep Mode", on page 501.
Parameters:
<Stop> float
Range: 300kHz to RFmax
Increment: 0.01Hz
*RST: 500 MHz
Default unit: Hz
Example: See Example "Setup an RF frequency or power sweep"
on page 1206
Manual operation: See "Start Frequency/Stop Frequency" on page 513
[:SOURce<hw>]:FREQuency:STEP:MODE <Mode>
Defines the type of step size to vary the RF frequency at discrete steps with the com-
mands FREQ UP or FREQ DOWN.
SOURce Subsystem