Rohde & Schwarz R&S SMW200A - Source:frequency:converter Subsystem

Remote Control Commands
R&S
®
SMW200A
1133User Manual 1175.6632.02 ─ 30
You can define the step mode for each path separately.
Parameters:
<Mode> DECimal | USER
DECimal
Increases or decreases the level in steps of ten.
USER
Increases or decreases the level in increments, set with the
command FREQ:STEP[:INCR].
*RST: DECimal
Example:
// increasing the RF frequency with a step size of 50 KHz
SOURce1:FREQuency:STEP 50E3
SOURce1:FREQuency:STEP:MODE USER
SOURce1:FREQuency:CW UP
Manual operation: See "Variation Active" on page 465
[:SOURce<hw>]:FREQuency:STEP[:INCRement] <Increment>
Sets the step width.
You can use this value to vary the RF frequency with command FREQ UP or FREQ
DOWN, if you have activated FREQ:STEP:MODE USER.
Note: This value also applies to the step width of the rotary knob on the instrument
and, in user-defined step mode, increases or decreases the frequency.
Parameters:
<Increment> float
Range: 0 Hz to RFmax - 100 kHz
Increment: 0.01 Hz
*RST: 1E6
Example: See Example "Frequency configuration" on page 1124
Manual operation: See "Variation Step" on page 465
14.19.7 SOURce:FREQuency:CONVerter Subsystem
The SOURce:FREQuency:CONVerter subsystem contains the commands used to
define and query the frequency overrange parameters of the specific R&S SZU100A
IQ Upconverter.
SOURce Subsystem