Rohde & Schwarz R&S SMW200A - Page 1134

Remote Control Commands
R&S
®
SMW200A
1134User Manual 1175.6632.02 ─ 30
Example: Querying the frequency overrange provided by an R&S SZU100A IQ
Upconverter
// Query the information wether the connected R&S SZU
// provides an extended frequency range
// Enable the frequency overrange and query the frequency overrange limits
SOURce1:FREQuency:CONVerter:EXTernal:OVERrange:ALLowed?
SOURce1:FREQuency:CONVerter:EXTernal:OVERrange 1
SOURce1:FREQuency:CONVerter:EXTernal:OVERrange:FREQuency:MIN?
SOURce1:FREQuency:CONVerter:EXTernal:OVERrange:FREQuency:MAX?
[:SOURce<hw>]:FREQuency:CONVerter:EXTernal:OVERrange:ALLowed[:STATe]?........... 1134
[:SOURce<hw>]:FREQuency:CONVerter:EXTernal:OVERrange:FREQuency:MAX?........... 1134
[:SOURce<hw>]:FREQuency:CONVerter:EXTernal:OVERrange:FREQuency:MIN?............ 1135
[:SOURce<hw>]:FREQuency:CONVerter:EXTernal:OVERrange[:STATe]........................... 1135
[:SOURce<hw>]:FREQuency:CONVerter:EXTernal:OVERrange:ALLowed[:
STATe]?
Queries if the connected R&S SZU provides the extended frequency range.
If confirmed, the R&S SMW indicates the correpsonding parameters in the "RF Fre-
quency" dialog, see "Frequency Overrange" on page 464.
Return values:
<OverrangAllowed> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Querying the frequency overrange provided by an
R&S SZU100A IQ Upconverter" on page 1134
Usage: Query only
[:SOURce<hw>]:FREQuency:CONVerter:EXTernal:OVERrange:FREQuency:
MAX?
Indicates the minimum and maximum frequency range values of the connected
R&S SZU.
The frequency overrange is based on the calibration data of the specific device.
Return values:
<OverrangFreqMax> float
Range: OverrangeMin to OverrangeMax
Increment: 0.01
*RST: OverrangeMax
Usage: Query only
Manual operation: See "Maximal Frequency" on page 465
SOURce Subsystem