Rohde & Schwarz R&S SMW200A - Page 1138

Remote Control Commands
R&S
®
SMW200A
1138User Manual 1175.6632.02 ─ 30
DBM3|DB3
(setting only)
Provided only for backward compatibility with other
Rohde & Schwarz signal generators.
The R&S SMW accepts these values and maps them automati-
cally as follows:
DBM3 = DBM2, DB3 = DB2
AUTO
The gain value is retrieved form the connected R&S SZU. The
I/Q modulator is configured automatically.
*RST: DB4
Example:
SOURce1:BB:IQGain DB2
SOURce1:IQGain DB2
Manual operation: See "Baseband Gain" on page 452
[:SOURce<hw>]:IQ:CREStfactor <CrestFactor>
Specifies the crest factor for the external analog signal.
Parameters:
<CrestFactor> float
Range: 0 to 35
Increment: 0.01
*RST: 0
Default unit: dB
Example:
IQ:CRES 10
specifies 10 dB crest factor for the external analog signal.
Manual operation: See "Crest Factor" on page 452
[:SOURce<hw>]:IQ:SWAP[:STATe] <State>
Swaps the I and Q channel.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
IQ:SWAP ON
swaps the I and Q channel.
Manual operation: See "I/Q Swap" on page 451
[:SOURce<hw>]:IQ:WBSTate <WbState>
Activates I/Q wideband mode.
This setting automatically optimizes the settings for wideband modulation signals (>
5 MHz, State ON).
SOURce Subsystem