Rohde & Schwarz R&S SMW200A - Page 1140

Remote Control Commands
R&S
®
SMW200A
1140User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:MODE.................................................................1142
[:SOURce<hw>]:IQ:OUTPut:LEVel.................................................................................1142
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:COUPling[:STATe]........................................1142
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:I................................................................. 1143
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:Q................................................................1143
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:OFFSet:I............................................................. 1143
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:OFFSet:Q............................................................1143
[:SOURce<hw>]:IQ:OUTPut:ANALog:STATe <State>
Activates the specified analog I/Q output.
Note: By default, the output connectors [I/Q Out x] are deactivated.
Suffix:
:SOURce<hw>
.
1|2
Selects the [I/Q Out] connectors
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example:
SOURce:IQ:OUTPut:ANALog:STATe ON
Activates the output of the analog I/Q signal on the [I/Q Out 1]
connectors.
Manual operation: See "State" on page 185
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:PRESet
Sets the default settings (*RST values specified for the commands).
Not affected are:
●
The state set with the command [:SOURce<hw>]:IQ:OUTPut:ANALog:STATe.
●
If SCONfiguration:EXTernal:PBEHaviour 1, the I/Q ouptput type set with
the command [:SOURce<hw>]:IQ:OUTPut[:ANALog]:TYPE.
Example:
See Example "Enabling and configuring the analog output"
on page 1139.
Usage: Event
Manual operation: See "Set to Default" on page 185
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:SETTing:CATalog?
Queries the files with I/Q output settings in the default directory. Listed are files with the
file extension *.iqout.
Return values:
<Catalog> string
Usage: Query only
SOURce Subsystem