Rohde & Schwarz R&S SMW200A - Page 1142

Remote Control Commands
R&S
®
SMW200A
1142User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:MODE <Mode>
Determines the mode for setting the output parameters.
Parameters:
<Mode> FIXed | VARiable
FIXed
Locks the I/Q output settings
VARiable
Unlocks the settings
*RST: FIXed
Example: See Example "Enabling and configuring the analog output"
on page 1139.
Manual operation: See "Mode" on page 186
[:SOURce<hw>]:IQ:OUTPut:LEVel
<Level>
Sets the off-load voltage Vp of the analog I/Q signal output.
The value range is adjusted so that the maximum overall output voltage does not
exceed 4V, see "Maximum overall output voltage" on page 184.
Parameters:
<Level> float
Range: 0.04V to 4V (R&S SMW-B10) / 0.04V to 2V
(R&S SMW-B9)
Increment: 1E-4
*RST: 1
Default unit: V
Example: See Example "Enabling and configuring the analog output"
on page 1139.
Manual operation: See "I/Q Level Vp EMF" on page 187
[:SOURce<hw>]:IQ:OUTPut[:ANALog]:BIAS:COUPling[:STATe] <State>
Couples the bias setting of the I and Q signal components.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Enabling and configuring the analog output"
on page 1139.
Manual operation: See "Couple I/Q Bias" on page 187
SOURce Subsystem