Rohde & Schwarz R&S SMW200A - Page 1148

Remote Control Commands
R&S
®
SMW200A
1148User Manual 1175.6632.02 ─ 30
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:POWer:VIA <Via>
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:POWer:VIA <Via>
Parameters:
<Via> PEP | LEVel
*RST: PEP
Manual operation: See "Signal Output" on page 180
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:POWer:PEP <Pep>
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:POWer:PEP <Pep>
Enters the peak level of the output signal relative to full scale of 0.5 V (in terms of dB
full scale).
Parameters:
<Pep> float
Range: -80 to 0
Increment: 0.01
*RST: 0
Example:
:SOURce:IQ:OUTPut:DIGital:BBMM2:POWer:PEP -10
Manual operation: See "Signal Output" on page 180
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:POWer:LEVel <Level>
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:POWer:LEVel <Level>
Enters the RMS level of the output signal.
Parameters:
<Level> float
Range: -80 to 0
Increment: 0.01
*RST: 0
Example:
SOURce:IQ:OUTPut:DIGital:BBMM2:POWer:LEVel -10
Manual operation: See "Signal Output" on page 180
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:POWer:STEP:MODE <Mode>
[:SOURce]:IQ:OUTPut:DIGital:FADer<ch>:POWer:STEP:MODE <Mode>
Defines the type of step size to vary the digital output power step-by-step.
Parameters:
<Mode> DECimal | USER
DECimal
increases or decreases the level in steps of ten.
SOURce Subsystem