Rohde & Schwarz R&S SMW200A - Page 1151

Remote Control Commands
R&S
®
SMW200A
1151User Manual 1175.6632.02 ─ 30
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:CHANnel<st0>:NAMe
<DigIqHsCHName>
Sets the channel name.
Parameters:
<DigIqHsCHName> string
Example: See Example "Enabling and configuring the HS DIG I/Q digital
outputs" on page 1144.
Options: R&S SMW-K19
Manual operation: See "Name" on page 178
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:CHANnel<st0>:SRATe
<DigIqHsSratChan>
Sets the sample rate per channel.
Parameters:
<DigIqHsSratChan> float
Range: 400 to max*
Increment: 0.001
*RST: 100E6
*)
max = 250E6 ("System Config > Mode = Advanced")/ max =
1250E6 ("System Config > Mode = Standard")
See also Chapter 4.3.4, "Supported Digital Interfaces Depending
on the System Configuration", on page 119.
Example: See Example "Enabling and configuring the HS DIG I/Q digital
outputs" on page 1144.
Options: R&S SMW-K19
Manual operation: See "Sample Rate" on page 178
[:SOURce]:IQ:OUTPut:DIGital:BBMM<ch>:CHANnel<st0>:STATe
<DigIqHsOutChSta>
Enables the channel.
Parameters:
<DigIqHsOutChSta> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Enabling and configuring the HS DIG I/Q digital
outputs" on page 1144.
Options: R&S SMW-K19
Manual operation: See "Active" on page 179
SOURce Subsystem