Remote Control Commands
R&S
®
SMW200A
1163User Manual 1175.6632.02 ─ 30
Example: See Example "Setup an LF sweep" on page 1152.
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RETRace <State>
Activates that the signal changes to the start frequency value while it is waiting for the
next trigger event.
You can enable this feature, when you are working with sawtooth shapes in sweep
mode "Single" or "External Single".
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Manual operation: See "Retrace" on page 511
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:RUNNing?
Queries the current status of the LF frequency sweep mode.
Return values:
<State> 0 | 1 | OFF | ON
Example: See Example "Setup an LF sweep" on page 1152.
Usage: Query only
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SHAPe <Shape>
Sets the cycle mode for a sweep sequence (shape).
Parameters:
<Shape> SAWTooth | TRIangle
*RST: SAWTooth
Example: See Example "Setup an LF sweep" on page 1152.
Manual operation: See "Shape" on page 511
[:SOURce<hw>]:LFOutput:SWEep[:FREQuency]:SPACing <Spacing>
Selects linear or logarithmic sweep spacing.
Parameters:
<Spacing> LINear | LOGarithmic
*RST: LINear
Example: See Example "Setup an LF sweep" on page 1152.
Manual operation: See "Spacing" on page 511
SOURce Subsystem
To Next Page
Loading...