Rohde & Schwarz R&S SMW200A - Page 1181

Remote Control Commands
R&S
®
SMW200A
1181User Manual 1175.6632.02 ─ 30
Parameters:
<BWidth> float
Range: 100E3 to 10E6
Increment: 100E3
*RST: 100E3
Example: See Example "Configuring the noise generator" on page 1179.
Manual operation: See "Bandwidth" on page 557
[:SOURce<hw>]:NOISe:BWIDth:STATe <State>
Activates noise bandwidth limitation.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Configuring the noise generator" on page 1179.
Manual operation: See "Bandwidth" on page 557
[:SOURce<hw>]:NOISe:DISTribution <Distribution>
Sets the distribution of the noise power density.
Parameters:
<Distribution> GAUSs | EQUal
*RST: GAUSs
Example: See Example "Configuring the noise generator" on page 1179.
Manual operation: See "Distribution" on page 557
[:SOURce<hw>]:NOISe:LEVel<ch>:RELative?
Queries the level of the noise signal per Hz in the total bandwidth.
Return values:
<Relative> float
Range: -149.18 to -52.67
Increment: 0.1
*RST: -69.84
Example: See Example "Configuring the noise generator" on page 1179.
Usage: Query only
Manual operation: See "Noise Density" on page 559
SOURce Subsystem