Rohde & Schwarz R&S SMW200A - Page 1182

Remote Control Commands
R&S
®
SMW200A
1182User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:NOISe:LEVel<ch>[:ABSolute]?
Queries the level of the noise signal in the system bandwidth within the enabled band-
width limitation.
Return values:
<Absolute> float
*RST: 3.84 MHz
Example: See Example "Configuring the noise generator" on page 1179.
Usage: Query only
Manual operation: See "Noise Level" on page 559
14.19.13.2
Impulsive Noise Commands
Option: R&S SMW-K810.
[:SOURce<hw>]:NOISe:IMPulsive[:STATe]......................................................................1182
[:SOURce<hw>]:NOISe:IMPulsive:CI............................................................................. 1182
[:SOURce<hw>]:NOISe:IMPulsive:FRAMe......................................................................1183
[:SOURce<hw>]:NOISe:IMPulsive:PULSe...................................................................... 1183
[:SOURce<hw>]:NOISe:IMPulsive:MINSpace..................................................................1183
[:SOURce<hw>]:NOISe:IMPulsive:MAXSpace................................................................ 1183
[:SOURce<hw>]:NOISe:IMPulsive[:BURSt]:DURation?.................................................... 1183
[:SOURce<hw>]:NOISe:IMPulsive[:STATe] <ImpulsiveState>
Enables or disables the impulsive noise generator.
Parameters:
<ImpulsiveState> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Generating impulsive noise" on page 1180.
Manual operation: See "State" on page 436
[:SOURce<hw>]:NOISe:IMPulsive:CI <IplsCI>
Specifies the ratio of the wanted signal (C) to the impulsive noise signal (I).
Parameters:
<IplsCI> float
Range: -35 to 60
Increment: 0.01
*RST: 20
Example: See Example "Generating impulsive noise" on page 1180.
Manual operation: See "C/I" on page 436
SOURce Subsystem