Rohde & Schwarz R&S SMW200A - Source:phase Subsystem

Remote Control Commands
R&S
®
SMW200A
1187User Manual 1175.6632.02 ─ 30
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Using pulse generator as source for pulse modu-
lation" on page 1186.
Manual operation: See "Pulse Output State" on page 551
[:SOURce<hw>]:PGENerator:STATe <State>
Enables the output of the video/sync signal.
If the pulse generator is the current modulation source, activating the pulse modulation
automatically activates the signal output and the pulse generator.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Example "Using pulse generator as source for pulse modu-
lation" on page 1186.
14.19.15 SOURce:PHASe Subsystem
This subsystem contains the commands for adjusting the phase of the RF output signal
relative to a reference signal of the same frequency.
Example: Programming Example
// change the phase relative to the current phase
SOURce1:PHASe 2 DEG
// adopt the setting as the current phase
SOURce1:PHASe:REFerence
The following commands are available:
[:SOURce<hw>]:PHASe................................................................................................1187
[:SOURce<hw>]:PHASe:REFerence.............................................................................. 1188
[:SOURce<hw>]:PHASe <Phase>
Sets the phase variation relative to the current phase.
Parameters:
<Phase> float
Range: -720 to 720
Increment: 0.1
*RST: 0
Default unit: DEG
Example: See Example "Programming Example" on page 1187.
SOURce Subsystem