Rohde & Schwarz R&S SMW200A - Page 1201

Remote Control Commands
R&S
®
SMW200A
1201User Manual 1175.6632.02 ─ 30
Parameters:
<Frequency> float
Range: 1E6 to 100E6
Increment: 0.1
*RST: n.a. (factory preset: 1E7)
Default unit: Hz
Example: See Example "Configuring the reference oscillator"
on page 1199.
Options: R&S SMW-K704
Manual operation: See "Variable Reference Frequency" on page 476
[:SOURce]:ROSCillator:EXTernal:SBANdwidth
<SBandwidth>
Selects the synchronization bandwidth for the external reference signal.
Depending on the RF hardware version, and the installed options, the synchronizsation
bandwidth varies.
For more information, see data sheet.
Parameters:
<SBandwidth> WIDE | NARRow
NARRow
The synchronization bandwidth is <1 Hz.
WIDE
Uses the widest possible synchronization bandwidth.
*RST: n.a. (factory preset)
Example: See Example "Configuring the reference oscillator"
on page 1199.
Manual operation: See "Synchronization Bandwidth" on page 476
[:SOURce]:ROSCillator:EXTernal:MLRange?
Queries the minimum locking range for the selected external reference frequency.
Depending on the RF hardware version, and the installed options, the minimum locking
range vaies.
For more information, see data sheet.
Return values:
<MinLockRange> string
Example:
SOUR:ROSC:EXT:MLR?
Usage: Query only
Manual operation: See "Minimum Locking Range" on page 477
SOURce Subsystem