Rohde & Schwarz R&S SMW200A - Page 1207

Remote Control Commands
R&S
®
SMW200A
1207User Manual 1175.6632.02 ─ 30
// the frequency sweep is running
// For manual step RF sweep use the following commands
*RST; *CLS
// Activate manual step RF sweep
SOURce1:SWEep:FREQuency:MODE MANual
// Activate the RF frequency sweep.
SOURce1:FREQuency:MODE SWEep
// Activate RF Output1.
Output1:STATe 1
// Input the frequency manually for each step
SOURce1:FREQuency:MANual 200 MHz
SOURce1:FREQuency:MANual 201 MHz
// Alternatively use the UP or DOWN commands with the set step width.
SOURce1:SWEep:FREQuency:STEP:LINear 1 MHz
SOURce1:FREQuency:MANual UP
// Activate combined RF frequency / level sweep
*RST; *CLS
*RST; *CLS
SYSTem:DISPlay:UPDate OFF
TRIGger1:FSWeep:SOURce SINGle
SOURce1:SWEep:COMBined:MODE AUTO
SOURce1:SWEep:COMBined:COUNt 200
SOURce1:FREQuency:STARt 1000000000 Hz
SOURce1:FREQuency:STOP 5000000000 Hz
SOURce1:POWer:STARt -30 dBm
SOURce1:POWer:STOP -10 dBm
SOURce1:SWEep:COMBined:RETRace 1
SOURce1:SWEep:COMBined:SHAPe SAWT
SOURce1:SWEep:COMBined:DWELl 0.01
// Activate combined RF frequency/level sweep
SOURce1:FREQuency:MODe COMB
// Activate RF Output1.
Output1:STATe 1
// Execute combined frequency / level sweep
SOURce1:SWEep:COMBined:EXECute
[:SOURce<hw>]:SWEep:POWer:AMODe.......................................................................1208
[:SOURce<hw>]:SWEep:POWer:DWELl.........................................................................1208
[:SOURce<hw>]:SWEep:POWer:MODE.........................................................................1209
[:SOURce<hw>]:SWEep:POWer:POINts........................................................................ 1209
[:SOURce<hw>]:SWEep:POWer:SPACing:MODE?......................................................... 1209
[:SOURce<hw>]:SWEep:POWer:STEP[:LOGarithmic]..................................................... 1210
[:SOURce<hw>]:SWEep[:FREQuency]:DWELl................................................................1210
[:SOURce<hw>]:SWEep[:FREQuency]:MODE................................................................1210
[:SOURce<hw>]:SWEep[:FREQuency]:POINts................................................................1211
[:SOURce<hw>]:SWEep[:FREQuency]:SPACing............................................................. 1211
[:SOURce<hw>]:SWEep:POWer:SHAPe........................................................................1212
[:SOURce<hw>]:SWEep[:FREQuency]:SHAPe............................................................... 1212
[:SOURce<hw>]:SWEep:POWer:EXECute..................................................................... 1212
SOURce Subsystem