Rohde & Schwarz R&S SMW200A - Page 1213

Remote Control Commands
R&S
®
SMW200A
1213User Manual 1175.6632.02 ─ 30
[:SOURce<hw>]:SWEep:POWer:RUNNing?
[:SOURce<hw>]:SWEep[:FREQuency]:RUNNing?
Queries the current sweep state.
Return values:
<State> 0 | 1 | OFF | ON
Example: See Example "Setup an RF frequency or power sweep"
on page 1206.
Usage: Query only
[:SOURce<hw>]:SWEep[:FREQuency]:STEP:LOGarithmic <Logarithmic>
Sets a logarithmically determined step width for the RF frequency sweep. The value is
added at each sweep step to the current frequency.
See Chapter 8.7.2.1, "Correlating Parameters in Sweep Mode", on page 501.
Parameters:
<Logarithmic> float
The unit is mandatory.
Range: 0.01 to 100
Increment: 1E-3
*RST: 1
Default unit: PCT
Example: See Example "Setup an RF frequency or power sweep"
on page 1206.
Manual operation: See "Step Linear/Step Logarithmic" on page 514
[:SOURce<hw>]:SWEep[:FREQuency]:STEP[:LINear] <Linear>
Sets the step width for linear sweeps.
See Chapter 8.7.2.1, "Correlating Parameters in Sweep Mode", on page 501.
Omit the optional keywords so that the command is SCPI-compliant.
Parameters:
<Linear> float
Range: 0.001 Hz to (STOP - STARt)
Increment: 0.01
Example: See Example "Setup an RF frequency or power sweep"
on page 1206.
Manual operation: See "Step Linear/Step Logarithmic" on page 514
[:SOURce<hw>]:COMBined:FREQuency:STARt <CombFreqStart>
Sets the start frequency of the combined RF frequency / level sweep.
SOURce Subsystem