Rohde & Schwarz R&S SMW200A - Page 1214

Remote Control Commands
R&S
®
SMW200A
1214User Manual 1175.6632.02 ─ 30
See Chapter 8.7.2.1, "Correlating Parameters in Sweep Mode", on page 501.
Parameters:
<CombFreqStart> float
Range: -59999E5 to 12E9
Increment: 0.01
*RST: 100E6
Example: See Example "Setup an RF frequency or power sweep"
on page 1206.
Manual operation: See "Start Frequency/Stop Frequency" on page 513
[:SOURce<hw>]:COMBined:FREQuency:STOP
<CombFreqStop>
Sets the end frequency of the combined RF frequency / level sweep.
Parameters:
<CombFreqStop> float
Range: -59999E5 to 12E9
Increment: 0.01
*RST: 500E6
Example: See Example "Setup an RF frequency or power sweep"
on page 1206.
Manual operation: See "Start Frequency/Stop Frequency" on page 513
[:SOURce<hw>]:COMBined:POWer:STARt <CombPowStart>
Sets the start level value of the combined RF frequency / level sweep.
See Chapter 8.7.2.1, "Correlating Parameters in Sweep Mode", on page 501.
Parameters:
<CombPowStart> float
Range: -245 to 120
Increment: 0.01
*RST: -30
Example: See Example "Setup an RF frequency or power sweep"
on page 1206.
Manual operation: See "Start Level / Stop Level" on page 515
[:SOURce<hw>]:COMBined:POWer:STOP <CombPowStop>
Sets the stop level value of the combined RF frequency / level sweep.
SOURce Subsystem