Remote Control Commands
R&S
®
SMW200A
1233User Manual 1175.6632.02 ─ 30
Example:
:SYSTem:HELP:EXPort
MMEM:CDIR?
// "/var/user"
MMEM:CAT?
// ..,"Log,DIR,4096","help.tgz,BIN,69836600"
// confirms that help zip archive is saved.
Usage: Event
Manual operation:: "Setup > Help > Export Help to User Path"
:SYSTem:IDENtification <Identification>
Selects the mode to determine the "IDN String" and the "OPT String" for the instru-
ment, selected with command :SYSTem:LANGuage.
Note: While working in an emulation mode, the R&S SMW specific command set is
disabled, that is, the SCPI command SYST:IDEN is discarded.
Parameters:
<Identification> AUTO | USER
AUTO
Automatically determines the strings.
USER
User-defined strings can be selected.
*RST: n.a. (factory preset: AUTO)
Example:
SYST:IDEN AUTO
Automatically assigns the OPT and IDN strings according to the
selected instrument language.
Manual operation: See "Mode" on page 791
:SYSTem:IDENtification:PRESet
Sets the *IDN and *OPT strings in user defined mode to default values.
Example:
SYST:IDEN USER
SYST:IDEN:PRES
Usage: Event
Manual operation: See "Set to Default" on page 791
:SYSTem:IRESponse <IdnResponse>
Defines the user defined identification string for *IDN.
Note: While working in an emulation mode, the instrument's specific command set is
disabled, i.e. the SCPI command SYST:IRES is discarded.
Parameters:
<IdnResponse> string
SYSTem Subsystem
To Next Page
Loading...