Rohde & Schwarz R&S SMW200A - UNIT Subsystem

Remote Control Commands
R&S
®
SMW200A
1255User Manual 1175.6632.02 ─ 30
Usage: Event
Manual operation: See "Execute Single Sweep" on page 512
:TRIGger<hw>:LFFSweep
Executes an LF frequency sweep in the following configuration:
●
TRIG:LFFS:SOUR SING
●
LFO:SWE:MODE AUTO
Example:
LFO:SWE:MODE AUTO
TRIG:LFFS:SOUR SING
TRIG:LFFSweep
Usage: Event
14.24
UNIT Subsystem
The UNIT subsystem is used to set default units for parameters if no unit is indicated in
a command. These settings are valid for the entire instrument.
Example: Setting default units for remote control
UNIT:POW V
UNIT:ANGL DEG
UNIT:VEL KMH
Sets V (volts) as unit of all power parameters, DEG (degrees) for the phase modulation
angle and KMH for the speed.
:UNIT:ANGLe...............................................................................................................1255
:UNIT:POWer...............................................................................................................1255
:UNIT:VELocity............................................................................................................ 1256
:UNIT:ANGLe <Angle>
Sets the default unit for phase modulation angle. The command affects no other
parameters, such as RF phase, or the manual control or display.
Parameters:
<Angle> DEGree | DEGRee | RADian
*RST: RADian
:UNIT:POWer <Power>
Sets the default unit for all power parameters. This setting affects the GUI, as well as
all remote control commands that determine power values.
UNIT Subsystem