Maintenance, Storage and Disposal
R&S
®
SMW200A
1284User Manual 1175.6632.02 ─ 30
17.3.4.1 Selftest Connections Settings
Access:
► Select "System Config > Setup > Maintenance > Selftest > Connections".
The "Connections" dialog contains the parameters for testing the signal flow at the
connectors.
The remote commands required to define these settings are described in Chap-
ter 14.22, "TEST Subsystem", on page 1247.
Execute Baseband Connections Test....................................................................... 1284
BNC Connections Test.............................................................................................. 1284
└ Source.........................................................................................................1284
└ Destination..................................................................................................1285
└ Execute BNC Connection Test....................................................................1285
└ Log Message.............................................................................................. 1285
Execute Baseband Connections Test
Performs a connection test on each of the internal digital baseband links.
The test implies to all installed options as baseband inputs, motherboard, universal
coding generators, fading simulators, and baseband outputs.
The result (succeeded or failed) is displayed in the status field on the right.
Remote command:
n.a.
BNC Connections Test
This function is password-protected. Unlock the protection level 1 to access it.
Source ← BNC Connections Test
Selects the BNC connector source to be tested.
Remote command:
:TEST:BB:BNC:SOURce on page 1249
Performing Maintenance Tasks
To Next Page
Loading...